How To Install A Water Tank Penguin

For those of you who're plug water tank/water toren/tandon at home we recommend that you follow the correct procedures for appropriate installation guide the installation of proper sources, as I will explain below that offered from PENGUIN.

Keep in mind that Every 1000 liters of water weighs 1 tonne, so it is important in considering the creation of a foundation that is able to withstand the weight of the whole tank. The Foundation made with good and right is very important for all of the water tank.

Tank placement instructions

1. Place the placement of the tank:
-Tower made of iron frame (no memilikit cracks on the tank holder trays).
Tower made of reinforced concrete
-Deck of reinforced concrete
-Ground floor made of reinforced concrete or brick couples
2. Foundation for the sockets of the tank should be clean, flat, and flat (try set with waterpass)
3. Where to make the Foundation must be solid and stable conditions
4. The width of the Foundation must be greater than the diameter of the tank.
5. Try not to place the water tank on top of the pipe installation and/or cable buried (to ease when the pipe or cable will be serviced or routine maintenance).
6. The place of which are to be fitted to the tank should be free from traffic or mobility so that all equipment related to the tank is secure from tampering.
7. avoid installing a water tank on top of the underground structures such as sheds, septic tanks, sewage, etc.

General Tanks are not designed for underground installation. Then there can be landfilled fully/partially

The surface holder/Foundation (click image to enlarge)

Holder/the right Foundation
Holder/the wrong Foundation
The limits of tolerance for the elasticity of the expansion/shrinkage of the Polyethylene Tank is owned by 3% from the dimensions of the tank. All tank connections should have provisions that allow movement when the tank to expand/shrink due to changes in temperature and load.

Installation of tank-pump

Use of the pump in accordance with the required pressure.
The pump is put in a place that is easy to check if a problem occurs.
Place the pump as close as possible to the water source, because with the suction pipe spacing decrease (suction) will add power pipe thrust (discharge).
Installation of the pump must not be direct or close to the outlet of the tank.
Use flexible connections to protect the walls of the tank from vibration of the pump. See Figure
The pump should be tied (dibaut) on the holder, in order to avoid movement and vibration when the pump is operating.
Reduce the number of bends in the connection pipe to prevent leaks in the installation of pipe and minimize the barriers.
Attach the Filter sand (typical analysis for strainer) for an easy source of water sucked shit.